Welcome to Plbg. Questions and discussions about toilets, sinks, faucets, drainage, venting, water heating, showers, pumps, water quality, and other exclusively PLUMBING related issues. Please refrain from asking where to purchase a product, or business, pricing, or legal questions, or for contractor referrals, or any questions not related to plumbing. Keep all posts positive and absolutely no advertising.
Instrument installation hook-up for your measuring equipment
Tank Settlement for Piping Stress Analysis – What Is Piping: All about Piping Engineering
Connecting a fitting to a gas pipe requires some Teflon tape to make a tight seal. This article is all about what Teflon tape to use on gas pipe and how to use it. Whenever you screw any two plumbing pipes or fittings together you should use some sort of sealant on the threads. This goes for both water and gas piping. Typically the male end of a pipe has the threads and the female end the grooves. When you wrap Teflon tape around the threads before you screw in the pipe it seals all those little cracks and crevices where gas or water can escape.
The steps for installing the sink drain will depend on how different the new sink is from the old one, as well as what other components are being installed. For example, the new sink may have a different depth than the old one, so some alteration of the branch drain pipe fitting entering the wall may be necessary. If you're planning to replace a standard sink with a deep-basin sink, you may need to lower the drain fitting in the wall to match the lower height of the new sink drain.
The sewer pipe connecting a house to the municipal branch or main sewer line under the street in a typical installation is called a lateral. This is usually a 4-inch pipe that is buried below the frost line in a trench that is properly prepared and sloped. The slope is the most critical aspect of the job, as it determines how well the pipe drains by the force of gravity. The basic installation process of a new sewer lateral can be broken down into five major steps. All installation details are governed by the local code authority and must be approved through one or more inspections.